Specially formulated rubber, extruded through the tubular fabric. Minimum load loss thanks to its smooth liner surface. High temperature resistance.
Jacket manufactured with tubular weave with high-tenacity polyester thread. Free of defects such as broken threads, knots, etc.
Enriched with vast industrial experience, we are engaged in offering an excellent range of Diesel Engine Fire Fighting Pump.The most important aspect of Fire Protection package is the reliability of the fire fighting pumping system to ensure adequate water supply at required pressure at emergency conditions.
NAFFCO standard branch pipe is made by metal, suitable to use with fire hose assembly for fire fighting purpose. The branch pipe has male instantaneous coupling inlet manufactured to comply with BS 336:2010 standards.
Single jacket fire hose consists of an impermeable elastomeric lining, a synthetic fibre reinforcement and externally applied elastomeric coating to the reinforcement. Delivery hoses are non-percolating lay flat type used in fire fighting purpose. Hoses are suitable for use with couplings with the requirements of BS 336:2010 standards. Hose is intended for use at working pressure not exceeding 15 bar. Delivery hose are manufactured to comply BS 6391: 2009 Standards.
semi-rigid reel hoses are suitable for use in fixed fire fighting system. The hoses are available in sizes of 19 mm and 25 mm inside diameter. The hoses are flexible so that it can be rolled and kept on a drum.
The hose are intended for use at a maximum working pressure of 12 bar (1.2 MPa) and temperature range of -20°C to +60°C at ambient temperature condition in non aggressive or non-corrosive atmosphere.
The semi-rigid reel hoses are manufactured to comply with BSEN 694:2014 standards.
landing valves are suitable for installation on wet risers in a building for fire fighting purposes with permanently charged water from a pressurised supply.
The landing valves are oblique type with flanged inlet and are manufactured to comply to BS 5041 Part 1 standard with delivery hose connection and blank cap complying with BS 336:2010 standard.
The landing valves are classified under low pressure and are suitable for use at nominal inlet pressure up to 15 bar.
A non-return valve allows a medium to flow in only one direction. A non-return valve is fitted to ensure that a medium flows through a pipe in the right direction, where pressure conditions may otherwise cause reversed flow.
Lock Shield Valve is usually installed where unauthorized operation has to be avoided. A typical application of this valve is installing these at inlet pipe to the hose reel where it can be opened only by key and key kept by maintenance or fire safety department.
hand-held branch pipe is made by combination of Aluminium and plastics. The water flow control is by means of SHUT, JET and SPRAY. The branch pipe has male instantaneous coupling inlet.
A foot valve is a type of check valve that is typically installed at a pump or at the bottom of a pipe line (hence the name). Foot valves act like ball check valves, but have an open end with a shield or screen over it to block debris from entering the line.
NAFFCO fire hose reels provide a very effective fire fighting facility with a continuous supply of water available immediately. The construction and performance of a fire hose reel with semi-rigid hose ensures suitable installation in buildings and other construction works for use by the occupants. The fire hose reels are manufactured in both manual and automatic versions to comply to BS EN 671-1:2012 standard with semi-rigid hose complying with BSEN 694:2014 standards.
NAFFCO cabinets are designed to accommodate fire hose reel, fire fighting equipment and breeching inlet. Fire hose reel cabinets are manufactured to comply with BSEN 671-1 standard and breeching inlet cabinets are manufactured to comply to BS 5041-5 standard.